Status display I
This readout state is standard after startup or initialization.
Use [INFO] to obtain information about the value/measurement linked to
the displayed operating variables (1.1, 1.2, 1.3, 2, and 3).
See the operating variables shown in the display in this figure. 1.1, 1.2
and 1.3 are shown in small size. 2 and 3 are shown in medium size.
Status display II
See the operating variables (1.1, 1.2, 1.3, and 2) shown in the display in
this figure.
In the example, Speed, Motor current, Motor power and Frequency are
selected as variables in the first and second lines.
1.1, 1.2 and 1.3 are shown in small size. 2 is shown in large size.
Status display III:
This state displays the event and action of the Smart Logic Control. For
further information, see the section
Smart Logic Control
.
NOTE!
Status display III is not available on the filter LCP
Bottom section
always shows the state of the adjustable frequency drive in status mode.
Display contrast adjustment
Press [status] and [
▲
] for darker display
Press [status] and [
▼
] for brighter display
VLT AQUA Low Harmonic Drive Instruction
Manual
5 How to Operate the Low Harmonic Drive
MG.20.T1.22 - VLT
®
is a registered Danfoss trademark
5-3
5
