Parameter 1-10 Motor Construction
AC motor
Parameter 1-01 Motor Control Principle
U/f mode
VVC
+
Parameter 1-76 Start Current
-
+
Table 5.4 Active/inactive Parameters
6) Used when parameter 1-03 Torque Characteristics is constant power.
7) Not used when parameter 1-03 Torque Characteristics=VT.
8) Part of resonance damping.
Parameter 1-10 Motor Construction
AC motor
Parameter 1-01 Motor Control Principle
U/f mode
VVC
+
Parameter 1-80 Function at Stop
+
+
Parameter 1-82 Min Speed for Function at Stop [Hz]
(
parameter Par. 002
=Hz)
+
+
Parameter 1-90 Motor Thermal Protection
+
+
Parameter 1-93 Thermistor Resource
+
+
Parameter 2-00 DC Hold Current
+
+
Parameter 2-01 DC Brake Current
+
+
Parameter 2-02 DC Braking Time
+
+
Parameter 2-04 DC Brake Cut In Speed [Hz]
+
+
Parameter 2-10 Brake Function
+
see
9)
+
Parameter 2-11 Brake Resistor (ohm)
+
+
Parameter 2-12 Brake Power Limit (kW)
+
+
Parameter 2-16 AC brake Max. Current
-
+
Parameter 2-17 Over-voltage Control
+
+
Parameter 2-19 Over-voltage Gain
+
+
Parameter 2-20 Release Brake Current
+
+
Parameter 2-22 Activate Brake Speed [Hz]
+
+
Table 5.5 Active/inactive Parameters
9) Not AC brake
Parameter Lists
Programming Guide
MG06C602
Danfoss A/S © 7/2015 All rights reserved.
123
5
5
