4 Start-up and Functional Testing
4.1 Pre-start
CAUTION
Before applying power to the unit, inspect the entire installation as detailed in
. Check mark those items when
completed.
Inspect for
Description
☑
Auxiliary equipment
•
Look for auxiliary equipment, switches, disconnects, or input fuses/circuit breakers on the input
power side of the adjustable frequency drive or output side to the motor. Ensure that they are ready
for full speed operation.
•
Check function and installation of any sensors used for feedback to the adjustable frequency drive.
•
Remove power factor correction caps on motors, if present.
Cable routing
•
Use separate metallic conduits for each of the following:
•
input power
•
motor wiring
•
control wiring
Control wiring
•
Check for broken or damaged wires and loose connections.
•
Check that control wiring is isolated from power and motor wiring for noise immunity.
•
Check the voltage source of the signals, if necessary.
•
The use of shielded cable or twisted pair is recommended. Ensure that the shield is terminated
correctly.
Cooling clearance
•
Make sure that the top and bottom clearance is adequate to ensure proper airflow for cooling.
EMC considerations
•
Check for proper installation regarding electromagnetic compatibility.
Environmental consider-
ations
•
See equipment label for the maximum ambient operating temperature limits.
•
Humidity levels must be 5–95% non-condensing.
Fusing and circuit
breakers
•
Check for proper fusing or circuit breakers.
•
Check that all fuses are inserted firmly and in operational condition and that all circuit breakers are
in the open position.
Grounding
•
The unit requires a ground wire from its chassis to the building ground.
•
Check for good ground connections that are tight and free of oxidation.
•
Grounding to conduit or mounting the back panel to a metal surface is not a suitable ground.
Input and output power
wiring
•
Check for loose connections.
•
Check that motor and line power are in separate conduits or separated shielded cables.
Panel interior
•
Make sure that the unit interior is free of debris and corrosion.
Switches
•
Ensure that all switch and disconnect settings are in the proper positions.
Vibration
•
Check that the unit is mounted solidly or that shock mounts are used, as necessary.
•
Check for an unusual amount of vibration.
Table 4.1 Start-up Checklist
Start-up and Functional Tes...
Instruction Manual
40
Danfoss A/S © Rev. 2014-02-07 All rights reserved.
MG37A222
4
4
Summary of Contents for VLT AutomationDrive FC 302
Page 2: ......
