•
•
•
•
-
The maximum axial and radial load while assembling the motor and for any mechanical device connected to the shaft, must not
exceed the values shown in
. The shaft must be loaded slowly and in a constant manner: Avoid pulsating loads.
N O T I C E
The bearing could be permanently damaged if the maximum permitted forces are exceeded.
Table 128: Maximum Load Ratings
Motor size
Maximum radial force (Fr) in N
Maximum axial force (Fa) in N
Size 1
450
1050
Size 2
900
1700
Size 3
830
1740
Size 4
1940
2200
The maximum radial load ratings are based on the following assumptions:
The servo drives are operated with peak torque of the longest member of the frame size.
Fully reversed load is applied to the end of the smallest diameter standard mounting shaft extension.
Infinite life with standard 99% reliability.
Safety factor = 2
11.8 Connectors on the ISD 510/DSD 510 Servo Drive
11.8.1 X1 and X2: Hybrid Connector (M23)
The hybrid cable provides the supply (mains and auxiliary), the communication lines, and the safety supply for each line of servo
drives. Input and output connectors are connected inside the servo drive.
e
3
0
b
e
3
8
1
.1
0
C
B
A
3
7
6
D
PE
2
8
5
Illustration 135: Pin Assignment of X1 Male Hybrid Connector (M23)
AQ262449648484en-000101 / 175R1135
198 | Danfoss A/S © 2020.08
Specifications
VLT® Servo Drive System ISD 510/DSD 510
Operating Guide
