3.8 Final Assembly
Always assemble the hollow shaft cover (4) with the
delivered screws (5) as shown in
.
130BD421.12
1
4
5
2
3
1
Torque arm (optional)
2
Plastic cap
3
Eyebolt
4
Shaft cover
5
Shaft cover screws
Figure 3.5 Final Assembly
1.
Remove the eyebolt (3) and cover the hole with
the plastic cap (2). This ensures the hygienic
features of a smooth surface.
2.
Assemble the hollow shaft cover (4) with the
three screws (5) onto the OneGearDrive.
2a
Fasten the screws by hand.
2b
Using a flat wrench, turn the screws
180° clockwise.
The tightening torque is 4.5 Nm.
NOTICE!
The OneGearDrive does not require breather vents.
Never install breather vents instead of the oil screws.
Mechanical Installation
Instruction Manual
MG75C422
Danfoss A/S © 08/2014 All rights reserved.
11
3
3
