40 DKDHR
VI.GP.P1.02
Danfoss District Energy
Instructions
VX Solo II H2WP (ECL 210/A260)
11.7 VX Solo II H2WP (ECL 210/A260.1d)
Heating circuit
The temperature for the heating circuit is controlled electronically by
the Danfoss ECL controller. The supply temperature ist calculated by
the controller on basis of the outdoor temperature.
The ECL Comfort 210 controller is loaded with a selected application
by means of an ECL Application Key (Plug-&-Play). The Application
Key contains information about application, languages and factory
settings.
From factory the VX Solo II H2WP is loaded with Application 1d.
Other applications can, however, be loaded by means of the ECL
Application Key, and it is possible to update the controller with new
application software.
The controller is factory preset to turn off the heating automatically
in the summer period.
The controller settings can be changed in accordance with the en-
closed producer instructions for the mounted controller.
See ECL Application Key Box with ECL Comfort 210/310 user guide
and mounting guide, for further information.
We also refer to Danfoss Installation Guide für ECL Comfort 210, application
A260, whcih can be found on www.heating.danfoss.com
Substation for indirect heating for single-family, semi-detatched and
terraced houses as well as flats. With two heating circuits for radiator
and floor heating, and connection pipes for cylinder on the primary
side. For wall-mounting.
The temperature for the heating circuit is controlled by a Danfoss ECL
210 controller in combination with an electronic actuator. The ECL
controller acts as the brain of the heating system. It lets you easily
control and optimise system performance and operation.
Please note:
Your substation may look different than the substation shown, as
variants with other components may be supplied.
Instructions for the fitted components will always be supplied to-
gether with the substation.
