Page 8 of 32
Rev 0.95
2.
Unpacking and installation
Receiving the goods
The Shipping container and the Magnet Power Supply should be thoroughly inspected for signs
of obvious physical damage immediately upon receipt.
All materials in the container should be checked against the enclosed packing list. DANFYSIK
A/S will not be responsible for shortages against the packing list unless notified immediately.
The following must be included in the delivery:
•
To be defined
Instructions for unpacking
The Magnet Power Supply is shipped on a wooden pallet enclosed in either reinforced
cardboard or wood crate.
Remove the packing straps and nails. If packed in a wood crate, the top lid should be removed
first. If the equipment is damaged in any way, a claim should be filed with the shipping agent,
and a full report of the damage should be forwarded to DANFYSIK A/S or our local
agent/representative immediately.
Upon receipt of this report, you will be issued instructions for the repair, replacement or return
shipment.
Please include the Model no, Type no, Serial no and Order no for the Magnet Power Supply on
any communication with DANFYSIK A/S or our representatives.
Installation requirements
During installation of the Magnet Power Supply (MPS), local rules and regulations for electric
power and water supplies should be respected and the following conditions and installations
should be available.
•
A normal, dust free room with humidity not above 80 % and a room temperature within 15
to 35 centigrade.
•
The Control System is supplied from a 24Vdc. This is typically handled as an internal
voltage within the power supply. Please see Power Supply manual and drawing for details.
•
Ground connection according to the local authority regulation and the requirements for the
equipment.
