MAGNET POWER SUPPLY SYSTEM 9100
15
DANFYSIK A/S - DENMARK.
As usual any rule has exceptions and these are:
- If there is no need for parameters after activating the “
” button “Stand alone menu” there
is no need to press the “
” button again. [One ”
” equals “( )” ]
- Pressing the MENU button while editing a parameter will abort the operation. [Regret the
operation as an “ESC”]
- Remotely changing the command status to Remote will automatically abort any local
operation.
Hint:
To ease the use, the “
” Enter key may be used instead of one of the arrow keys in
some situations- i.e. if the action is given anyway. Eg. Standing on the top of a menu
the “
” will do the same as the “
” key or when standing in a menu containing a sub
menu the “
” will do the same as the “
” key. (Interferes a bit the mathematical
parentheses idea; but is fast to use in some cases)
Hint:
Pressing the MENU key the first displayed menu will either be the SET or the INTL
menu. The last one if at least one interlock is present. This minimizes the number of
buttons to be pressed to “MENU”, “
” , “
” for setting the output current or the
same key sequence to se the active internal interlocks. Actually the three lowest
vertical keys pressed from bottom up.
Changing a parameter is done with the arrow keys. (See also the help text at the bottom right of
the display). A cursor, shown as the digit inverse, marks the digit to be manipulated. Pressing
the “Enter” key ends the editing.
Hint:
Holding either the “
” or the “
” keys pressed when editing a number the auto
increment function will start.
If no menus have been used within 5 minutes, then the display will automatically be switched
back to the opening window aborting any current operation (security reason).
