MAGNET POWER SUPPLY SYSTEM 9100
45
DANFYSIK A/S - DENMARK.
Following are the SET UP commands for the standard software listed in alphabetic order.
Please be aware that some of these commands should only be used with caution.
See the SW appendix for detail explanation on every command.
„esc‟ SET UP COMMANDS. Summary
Following are the commands for the software driven “RAMP PROFILE” listed in alphabetic
order. Please see the SW manual for parameter formats and further detail description.
These commands are optionally available.
SW RAMP PROFILE COMMANDS “Arbitrary point method”. Summary
SW RAMP PROFILE COMMANDS “Equal Time slot method”. Summary
ESC<AD
Configures the AD converter
attaining and routing (Output rea-
ding adjustment or output reading in
% or Amps)
ESC<ADR
Configures the communication
address setting (in RS422
mode).
ESC<ADSET
Auto Configures the scaling
“gain” and Offset for an AD
converter channel.
ESC<AUX
Configures the special options
ESC<BAUD
Configures the Baud rate for the
serial lines.
ESC<COLDBOOT
Configures the power up state
(Wake up position)
(
P
r
e
f
e
r
r
e
d
n
e
w
c
o
m
m
a
n
d
:
DA 0)
ESC<CPURESET
Hardware reset / CPU reset
ESC<DA
Configures the Digital to Analog
converters. (Slew rate setting in
A/sec or set value in Amps)
ESC<DASET
Auto Configures the scaling
(gain) and Offset for a DA
converter channel.
ESC<LINE
Configures the protocol for the
serial lines.
ESC<POLDELAY
Configures the delay between
off and polarity switch change
CONT
Continue sequence operation
CSS
Clear sequence stack and poin-
ters.
FAST
Fast sequence timing
HALT
Halt sequence operation
MULT
Reads the multiplying factor
for the DAC scaling
MULT X
Writes a multiplying factor for
the DAC scaling
RRSP
Reset read sequence pointer
RSA
Read sequence and auto
increment
RSP
Read sequence position
(
P
r
RWSP XX
Reset write pointer
S2
Read sequence status
SLOW
Slow sequence timing
SPEED
Read sequence timing
STOP
Stop sequence executing
SYNC
Synchronization of sequence
TS
Trig sequence
WSA
Write sequence and auto
increment
WSP
Write Sequence position
