Daniela DAN6BSC, User Manual

P 

 I

 02 9604 1226    E 

 I

sales@danielaappliances.com.au    W

  |

 danielaappliances.com.au

PAG E   9

INSTALLATION OF ELECTRICAL

Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes 

and standards. This range hood must be properly grounded. Turn off electrical power at service 

entrance before wiring. If the supply cord is damaged, it must be replaced by the manufacturer, 

its service agent or similarly qualified persons in order to avoid a hazard.

INSTALLATION OF THE HOOD

NOTE: On stainless steel hoods, carefully remove the plastic protective film from all exterior 

surfaces of the hood and chimney prior to final installation.
NOTE:  At least two people will be required to mount the hood.

• 

Minimum hood distance above the cooker must not be less than 650mm for electric hobs 

and 700mm for gas hobs. A distance of 750mm above the cooker is highly recommended 

for best capture of cooking impurities.

• 

Distance over 750mm above the cooker are at the installer’s and user’s discretion - 

providing that ceiling height and flue length permit.

1. 

Secure the hood mounting bracket to the wall using (2) ST 5 x 50mm mounting screws and 

dry wall anchors. Align the hood body with the hood mounting bracket. Gently lower the 

hood until it securely engages the bracket.

2. 

Fix the discharge collar into the air outlet adapter.

3. 

Attach an adequate length of the 150mm round duct to the air outlet adapter.

4. 

Carefully slide the decorative chimney top down inside the decorative chimney bottom. 

Carefully place the decorative chimney bottom into the recessed area of the hood body top.

5. 

Secure the chimney mounting bracket to the wall using (2) ST 5 x 50mm mounting screws 

and dry wall anchors.

6. 

Raise the decorative chimney top until it’s holes align with the holes in the chimney 

mounting bracket (located on the wall).

7. 

Level the hood and secure the chimney with 2x chimney bracket screws.

8. 

Fix the decorative chimney bottom with 3 x decorative chimney bottom screws 

from inside the body.