FOR TECHNICAL QUESTIONS, CALL (877)432-6627
33
When lowering the lift
PAY CAREFUL ATTENTION
that all personnel and objects are kept clear.
ALWAYS
keep a visual line of site on the lift
AT ALL TIMES
.
ALWAYS
make sure that
ALL LOCKS
are disengaged.
If one of the locks inadvertently locks on descent the lift and/or vehicle may disrupt causing personal
injury or death.
ALWAYS REMOVE
tool trays, stands, etc. before lowering lift.
ALWAYS RELEASE
safety locks before attempting to lower lift.
ALWAYS POSITION
the lift arms and adapters to provide an unobstructed exit before removing ve-
hicle from lift area.
TO RAISE THE LIFT
To avoid personal injury and / or property damage, permit only trained personnel to operate lift. After
reviewing these instructions, get familiar with lift controls by running the lift through a few cycles before
loading vehicle on lift. Always lift the vehicle using all four adapters.
NEVER
raise just one end, one corner,
or one side of vehicle.
1. Before Loading: Lift must be fully lowered and service bay clear of all personnel before the vehicle is
brought on lift with the swing arms set to the full drive thru position.
2. Loading: Swing arms under vehicle and position
adapters at vehicle manufacturer’s recommended lift
points. Use height extenders or optional frame cradle
adapters when necessary to ensure good contact.
(See figure 34)
3. Some vehicles may have the manufacturer’s Service
Garage Lift Point locations identified by triangle shape
marks on the undercarriage (reference ANSI/SAE
J2184-1992). Also, there may be a label located on the
right front door jamb area showing specific vehicle lift
points.
Many specialty or modified vehicles cannot be raised on a two post frame engaging lift. Contact vehicle
manufacturer for raising or jacking details.
4. Position the vehicle for proper weight distribution. Adjust the arms under the vehicle to allow the
adapters to contact the vehicle at the manufacturer’s recommended pick up points.
5. If the specific vehicle’s lift points are not identified, or if the vehicle has additional or uniquely po-
sitioned payload, have a qualified person calculate the vehicle center of gravity or have the vehicle
center of gravity determined at a vehicle scale. Load the vehicle with the center of gravity midway
between adapters.
6. Push the RAISE button or rotate the control switch on the power unit.
Important Note:
Allow (2) seconds between motor starts. Failure to comply may cause motor burnout.
DANGER
WARNING
WARNING
Fig: 34
Summary of Contents for D-10 Series
Page 1: ...A ND VALIDATE D Rev D 06202018 P N 199824...
Page 46: ......
Page 47: ...D10ACX...
Page 52: ...Dannmar R EQUIPMENT...
