FOR TECHNICAL QUESTIONS, CALL (877)432-6627
35
11. DO NOT go near or under a raised vehicle if all four adapters are not in secure contact with vehicle at
vehicle manufacturer’s recommended lift points.
12. Repeat entire loading and raising procedures if required.
13. Lower lift onto safety locks.
VISUALLY CONFIRM THAT ALL PRIMARY SAFETY LOCKS ARE ENGAGED BEFORE ENTERING WORK
AREA.
Suspension components us on this lift are intended to raise and lower lift only and are not meant to be
load holding devices. Remain clear of elevated lift unless visual confirmation is made that all primary
safety locks are fully engaged and the lift is
LOWERED
onto the safety locks, refer to installation / opera-
tion manual for proper safety lock procedures and / or further instruction.
DO NOT enter work area or go under vehicle if safety locks are not engaged.
CLEAR AREA if vehicle is in danger of falling.
DO NOT position yourself between a wall and the lift. If the vehicle falls in that direction, you may be
severely injured.
Before attempting to lift pickup trucks or other truck frame vehicles, be sure that:
Vehicle frame is strong enough to support its weight and has not been weakened by modification
or corrosion.
Vehicle individual axle weight does not exceed one half lift capacity.
Adapters are in secure contact with frame atvehicle manufacturers recommended lift points.
Vehicle is stable on lift and neither front nor “tail” heavy.
Avoid excessive rocking of vehicle while on lift.
Always use safety stands as needed or when removing or installing heavy components.
TO LOWER THE LIFT
When lowering the lift
PAY CAREFUL ATTENTION
that all personnel and objects are kept clear.
ALWAYS
keep a visual line of site on the lift
AT ALL TIMES
.
ALWAYS
make sure that
ALL LOCKS
are disengaged.
If one of the locks inadvertently locks on descent the lift and / or vehicle may disrupt causing personal
injury or death.
1. Remove all tools or other objects from the lift area.
2. Raise lift off safety locks. Make sure you raise the lift by at least two inches to allow adequate clear-
ance for the locks to clear.
3. Pull both safety lock release cables.
4. Push the
LOWERING
valve handle on the power unit to lower.
5. Remain clear of lift when lowering vehicle. Observe pinch point warning decals.
6. Remove adapters from under vehicle and swing arms to full drive thru position before moving vehicle.
DANGER
WARNING
Summary of Contents for D-10 Series
Page 1: ...A ND VALIDATE D Rev D 06202018 P N 199824...
Page 46: ......
Page 47: ...D10ACX...
Page 52: ...Dannmar R EQUIPMENT...
