VISIT US ON THE WEB AT WWW.DANNMAR.COM
4
IMPORTANT SAFETY INSTRUCTIONS
READ THESE SAFETY INSTRUCTIONS ENTIRELY!
IMPORTANT NOTICE !
Do not attempt to install this lift if you have never been trained on basic automotive lift installation proce-
dures. Never attempt to lift components without proper lifting tools such as forklift or cranes stay clear of
any moving parts that can fall and cause injury.
1.
READ ALL INSTRUCTIONS.
2.
READ AND UNDERSTAND
all safety warning procedures before operating lift.
3.
KEEP AREA WELL LI
4.
WARNING! RISK OF EXPLOSION.
This equipment has internal arcing or sparking parts which should
not be exposed to flammable vapors. This machine should not be located in a recessed area or below
floor level.
5.
KEEP CONTROL HANDLES AND / OR BUTTONS
dry, clean and free from grease and oil.
6.
CARE MUST BE TAKEN
as burns can occur from touching hot parts.
7.
DO NOT
operate equipment with a damaged power cord or if the equipment has been dropped or
damaged until it has been examined by a qualified service person.
8.
DO NOT
let the power cord come in contact with hot manifolds or moving fan blades.
9.
IF AN EXTENSION CORD IS NECESSARY
, a cord with a current rating equal to or more than that of
the equipment should be used. Cords rated for less current than the equipment may overheat. Care
should be taken to arrange the cord so that it will not be tripped over or pulled.
10.
ALWAYS UNPLUG EQUIPMENT FROM ELECTRICAL OUTLET WHEN NOT IN USE.
Never use the
power cord to pull the power plug from the outlet. Grasp the plug and pull to disconnect.
11.
LET EQUIPMENT COOL COMPLETELY BEFORE PUTTING AWAY.
Loop power cord loosely around
equipment when storing.
12.
TO REDUCE THE RISK OF FIRE
, do not operate equipment in the vicinity of open containers of flam-
mable liquids (i.e., gasoline).
13.
ADEQUATE VENTILATION SHOULD BE PROVIDED
when working on operating internal combustion
engines.
14.
KEEP HAIR, LOOSE CLOTHING, FINGERS, AND ALL PARTS OF THE BODY AWAY FROM MOVING
PARTS.
15.
TO REDUCE THE RISK OF ELECTRIC SHOCK,
do not use on wet surfaces or expose to rain.
16.
USE ONLY AS DESCRIBED IN THIS MANUAL.
Use only manufacturer’s recommended attachments.
17.
DO NOT
raise vehicle on the lift until installation is completed as instructed in this manual.
18.
KEEP HANDS AND FEET CLEAR.
Remove hands and feet from any moving parts. Keep feet clear of
lift when lowering. Avoid pinch points.
19.
KEEP WORK AREA CLEAN.
Cluttered work areas invite injuries.
20.
CONSIDER WORK AREA ENVIRONMENT.
Do not expose equipment to rain. DO NOT use in damp or
wet locations. Keep area well li .
Summary of Contents for D-10 Series
Page 1: ...A ND VALIDATE D Rev D 06202018 P N 199824...
Page 46: ......
Page 47: ...D10ACX...
Page 52: ...Dannmar R EQUIPMENT...
