DB-70 Automatic Wheel Balancer
18
P/N 5900261 — Rev. A1 — January 2021
If you want to connect the Wheel Balancing Machine to a 110 VAC power source, simply verify the
power switch is set to 110 VAC and plug it in to a 110 VAC power outlet. No Electrician is needed to
use the Wheel Balancing Machine with a 110 VAC power source as shipped from the factory.
⚠
DANGER
All
electrical work (including changing a Plug from 110 VAC to 220 VAC) must be
done by a
licensed, certified Electrician
. If you do not use a licensed,
certified Electrician, you void your warranty and put everyone who uses the Wheel
Balancing Machine in danger of injury or, in rare cases, death.
To convert the Wheel Balancing Machine to use a 220 VAC power source:
1.
Make sure the Wheel Balancing Machine is
disconnected from the power source
.
If it is connected, disconnect it.
Do not begin to switch the Wheel Balancing Machine to
220 VAC until you are sure that power has been disconnected from the unit.
2.
Have a
licensed, certified Electrician
cut off the 110 VAC plug on the end of the Power Cord
and attach a 250 VAC NEMA 30A, 2-Pole, 3-Wire plug. The DB-70 does not come with this plug. You
must supply your own.
Do not change the 110 VAC plug to a 220 VAC plug unless you
are a licensed, certified Electrician.
The colors of the three exposed wires from the power cord are Brown, Blue, and Green/Yellow, the
European color code.
Important
: To connect the three exposed wires to an appropriate Plug or to hard-wire them, have
your Electrician follow the electrical codes for the country and locality in which you are
using the unit.
For example, if you are using the unit for 220V in the United States, the color codes of the power cord
wiring on the DB-70 correspond to:
Brown
: Live
Blue
: Live
Green/Yellow
: Ground
If you were using the unit in a European
country, the color codes on the wiring that
comes with the DB70 correspond to:
Brown
: Live
Blue
: Neutral
Green/Yellow
: Ground
Information about color code conventions in other regions and countries is available online. Make sure
your Electrician installs the Plug in accordance with all applicable local electrical codes.
3.
Change the setting of the Voltage
Selector Switch on the back panel of the
Tire Changer to
220V
.
This can be done using either your finger
or a slot screwdriver.
4.
Double check that Voltage Selector Switch to make sure it is set to the
220V
setting.
Summary of Contents for DB-70
