DB-70 Automatic Wheel Balancer
35
P/N 5900261 — Rev. A1 — January 2021
The Wheel is balanced when both the Inner and Outer
Windows show
00
.
It may take more than one time adding weights to get to
0.0 | 0.0
.
To balance a Wheel using ALU 2 Mode
:
a.
Make sure you are dressed appropriately: leather gloves, steel-toed work boots, back
belts, hearing protection, and ANSI-approved eye protection: safety glasses, face shield, or
goggles.
b.
Visually inspect the Balancer to make sure everything is in place. The Tire Cover should be
up
.
If you find any issues, fix them. If there are issues you cannot fix, refer to
c.
Make sure the Wheel you want to balance is both clean and free of any weights that may
have been put on previously. If it is dirty, clean it. Remove any existing weights.
Important:
When using Adhesive Weights, it is extremely important to
clean the Wheel
;
the cleaner the Wheel, the longer the
Adhesive Weight stays in place.
d.
Mount the Wheel on the Balancer.
Refer to
instructions, if needed.
e.
Turn the Balancer Off and then back On, to
reset, if required. The display should be flashing,
and
–a-
will appear in the Inner Display Window. On the Control Panel, press the
F
button
until the
ALU 2
Indication is lit.
f.
Input the wheel parameters. Slide the inner
distance arm to touch the Inner Plane and hold it
there to automatically determine the distance from
the side of the Balancer and the wheel diameter.
These parameters are entered into the Balancer’s
memory. The value should appear in the
Outer
Display Window
. You may also enter the values
manually using the
A
and
D
keys.
Note
: If the values appear incorrect you can turn
off the power to reset the machine and start
the process over.
g.
Determine the width of the wheel using the wheel
caliper and input this value using the front panel
button labelled
B
. The value should appear in the
Outer Display Window
. When all three
measurements are correct, you are done entering
measurements.
h.
Close the Tire Cover; the Wheel spins briefly.
ALU 2
Weight
Locations
Summary of Contents for DB-70
