DB-70 Automatic Wheel Balancer
17
P/N 5900261 — Rev. A1 — January 2021
4.
Vacuum each hole to remove debris Dannmar recommends using a wire brush and a vacuum to get
the hole very clean.
Do
not
ream the hole. Do
not
make the hole any wider than the drill bit made it.
5.
Place the Washer on the anchor and thread the nut partially down the anchor, then insert the Anchor
Bolt into the hole.
Note: The Expansion Sleeve of the Anchor Bolt may prevent the Anchor Bolt from passing
through the hole in the base of the Wheel Balancing Machine; this is normal. Use a hammer or
mallet to get the Expansion Sleeve through the base and down into the hole.
Even using a hammer or mallet, the Anchor Bolt should only go into the hole part of the way; this is
normal. If the Anchor Bolt goes all the way in with little or no resistance, the hole is too wide.
Once past the hole in the base, the Anchor Bolt eventually stops going down into the hole as the
Expansion Sleeve contacts the sides of the hole; this is normal.
6.
Hammer or mallet the Anchor Bolt the rest of the way down into the hole. Stop when the Washer is
snug against the base of the Wheel Balancing Machine.
7.
Use a torque wrench to tighten each Nut
clockwise
to 55 lbf-ft.
Important:
Do
not
use an impact wrench to torque the Anchor Bolts. Wrenching the Nut forces
the Wedge up, forcing out the Expansion Sleeve and pressing it tightly against the
Concrete.
Connecting to Power
⚠
DANGER
This Wheel Balancing Machine uses electrical energy; if your organization has
Lockout/Tag-out policies, implement them once the unit is connected to power.
The Wheel Balancing Machine comes configured for a 110 VAC power source. It may be converted to
function with 220 VAC, if desired.
1.
Plug.
The Power Cord has a 110 VAC three prong plug installed.
2.
Voltage Selector Switch.
The Voltage Switch (on the back of the unit, near the ID Label) is set to
the
110V
setting. Refer to the figure below.
Summary of Contents for DB-70
