DT-50 and DT-50A Tire Changer
26
P/N 5900260 — Rev. A1 — Dec. 2020
Turntable
The Turntable is where the Wheel and Tire that is to be demounted or mounted is to be placed.
Top and side views. Not to scale. Not all components shown.
The parts of the Turntable are:
•
Flat, round, steel piece.
This is the actual Turntable. It holds the other components. It can
rotate either clockwise or counter-clockwise.
–
To rotate clockwise:
Press
Down
and hold down the Turntable Foot Pedal.
–
To rotate counter-clockwise:
Press
Up
and hold up the Turntable Foot Pedal.
•
Clamp Mechanism
. The Clamp Mechanism moves in and out to clamp Wheels either externally
or internally. All four Clamp Mechanisms move together. They can all be in or they can all be out.
“External” and “Internal” clamping refer to the location of the Clamp in relation to the Wheel.
Side view. Some components exaggerated for clarity. Large arrows show direction Clamps are
pressing. Only one of the four Clamps shown. Not to scale. Not all components shown.
As a general rule, you clamp steel Wheels internally (Clamps push out against Wheel) and custom
and mag Wheels externally (Clamps push in against outside Rim edge).
Check with your
supervisor if you are unclear about which method to use for a particular set of
Wheels.
Summary of Contents for DT-50
