DT-50 and DT-50A Tire Changer
30
P/N 5900260 — Rev. A1 — Dec. 2020
•
Moving the Swing Arm
. Grab the section of the Shaft just under the Swing Arm to move the
Swing Arm left and right. Do not move the Swing Arm using the Shaft or the Shaft Spring.
Mount/Demount Head
The Mount/Demount Head is the main tool on the Tire Changer for demounting and mounting Tires.
The following drawing shows the Mount/Demount Head with the Demount and Mount Lips identified. It
also shows where the Tire Bead rides during demounting and mounting.
Side view. Not to scale. Not all components shown.
The Demount Lip and Mount Lip work as follows:
•
During
demounting
. The Tire Bead goes
over the Demount Lip
and
under
the
Mount Lip
.
•
During
mounting
. The Tire Bead goes
over the Mount Lip
and
under the Demount Lip
.
The Mount/Demount Head that comes with the Tire Changer is alloy steel, which includes plastic
inserts on the inside to avoid damaging Rims. Replace the plastic inserts after two months of use, or
as required. See the
section.
Alternatively, a plastic Tool Head and mounting flange are available. See the
the Dannmar website.
Tire Compression Roller
The Tire Compression Roller is a bolt-on attachment to the Mount/Demount Head. Prior to mounting
the top Bead, swing the compression roller into position and tighten the socket cap hex screw to
secure it.
When mounting the top Tire Bead, the
Compression Roller will provide
additional downward force on the
Bead, guiding it onto the
Wheel.
Summary of Contents for DT-50
