9
P
P
LANNING
LANNING
& I
& I
NSTALLATION
NSTALLATION
C
C
HECK
HECK
L
L
IST
IST
Unless you are knowledgeable and experienced in stove installation, we recommend your Glow Boy Appliance
receive a Pre-delivery Check and be installed by your local Specialty Retailer, NFI (National Fireplace Institute)
Pellet Specialist (USA) or WETT Certified Installer (CAN) .
COMPLETE THIS CHECK LIST PRIOR TO INSTALLING YOUR MULTI-FUEL APPLIANCE:
_____ Carefully read this "Owners Manual”
.
SAVE THIS MANUAL.
_____ Have your local Dealer
demonstrate all the operational, cleaning and maintenance steps
necessary for your stove.
_____ Select a location.
The design of your home and the stove placement will determine its value
as a source of heat. A pellet appliance depends primarily on air circulation to disperse its
heat. There are other practical considerations, which must be considered before a final
placement is decided on:
Existing Chimneys, Pellet Fuel Storage, Aesthetic Considerations, Roof Design (rafter
locations & roof pitch), Room Traffic, Clearances to Combustibles, and Existing Wiring.
_____
The installation of this appliance
must conform to local codes and applicable state and
federal requirements.
Becoming familiar with these requirements
before
installation is
essential.
_____
Sign and keep a copy of the
Pre-delivery Check List supplied by your Authorized Dealer, OR
“Dansons Certified Installer”, found inside our appliance or available online.
______ Attach your proof of purchase to this manual and keep on hand for warranty.
COMPLETE THIS CHECK LIST WHILE INSTALLING YOUR MULT—FUEL APPLIANCE:
_____ Carefully read the
ENTIRE
installation section first. Twice is better.
_____ Read the Installing Freestanding, Insert or Built-In sections.
_____
Determine
the location and measurement needed your chosen location.
_____
Be sure to pre-fit
all items before you install, fasten or install the stove permanently.
Remember measure twice, cut once.
_____
Ensure ALL
joints of “PL” vent and single wall stainless steel liner are tightly connected,
sealed with RTV Silicone or Hi-Temp foil tape
,
including to the exhaust connector
, and
is correctly installed. (Follow vent manufacturer’s instructions.)
COMPLETE THIS CHECK LIST PRIOR TO LIGHTING YOUR FIRST FIRE:
_____ Obtain final inspection
and approval by local building officials.
_____ Carefully
clean all marks off the brass, nickel or pewter parts
before the first fire is lit. Use a
soft cloth and a gentle type cleaner.
Caution
: Never use an abrasive cleaner on any part of your
stove.
_____ Polish the hopper
to remove the oil type coating used in manufacturing.
_____
The high temp. stove paint used on your stove may take several hours of burning at a high fuel
setting to fully cure. During this time an odor, which is not harmful, may be evident. The area
around the stove should be well ventilated.
_____
Review and follow the
Lighting and Controls Instructions.
_____ Ensure that appliance is connected to a surge protection unit.
_____ Fill the hopper with quality pellets,
Close the Hopper Lid
, Using the CCI “AcuTron”,
(figure 5), PUSH the
FEED RATE
Touch Pad and this will start the auger and the combustion fan.
Glow Boy Pellet & Biomass
www.glowboystoves.com 9
