23
Record
Click the REC button, user may go to the Record interface. User may use the shuttle/jog
to set the channel number and status. Click the ENTER button to save current setup and
click the ESC button to exit.
One-window/multiple-window mode switch
Use the jog (inner dial) to select the window amount and use the shuttle (outer ring) to
switch the displayed channel.
Click the number button to go to the selected channel. For example, click number 1; user
may go to channel 1.
If user input channel number is greater than 10, user may work with the CAM button. The
input method is CAM+channel CAM. For example, click CAM+12+CAM, user
may go to channel 12.
PTZ control and color
In window-display mode, there are two ways for user to go to the PTZ control.
Click the PT button in the keyboard to enable the AUX function: PTZ control and color.
Select the PTZ control to go to the DVR PTZ control menu.
Input number i+PT (i=channel number), user may open the local PTZ control menu
via the keyboard.
2.3.7 Remote Operation (RS485)
2.3.7.1 The keyboard settings after PTZ connection
Before the operation, please make sure:
1) The A, B cable of the keyboard properly connects to the A, B cable of the speed
dome.
2) Turn on the speed dome and connect the video cable to the monitor.
3) Set the speed dome address. Please make sure userr keyboard RS485 address shall
be the same with the speed dome address here.
4) In the keyboard menu, from the Advanced->PTZ, user may set protocol, address,
baud rate, data bit, stop bit, parity and etc. User may select the protocol according to
userr speed dome and RS485 address is the same as the speed dome.
5) Please save current setup.
2.3.7.2 Operation
In this mode, user may use the network keyboard to control the PTZ of the speed dome.
Please input the number 0+PT to enable PTZ control.
Please refer to chapter 2.3.5.5 Pan/Tilt/Zoom for detailed information.
2.3.8 Remote Control
Remote control interface is shown as in Figure 2-9.