PRECISIONAIR WS PRODUCT INFORMATION MANUAL
3
UNPACKING
|
SAFETY
|
WARNING
UNPACKING, HANDLING, AND
INSPECTION
Thank you for purchasing a Dantherm
PrecisionAir WS unit. Please carefully review all
handling and installation instructions.
• HVAC systems should be maintained in
an upright position at all times to prevent
refrigerator oil migration.
• While unpacking, the unit should be inspected
for any damage that may have occurred
during shipment.
• Damage to the unit or packaging should be
immediately addressed with the shipping
carrier.
• Do not attempt to operate or repair the unit if
it appears to be damaged.
• Any damage as a result from mishandling
is not covered under Dantherm Cooling’s
standard warranty.
GENERAL SAFETY
Certain parts of electrical systems are inevitably
live or have a high operating temperature.
Observe caution at all times.
Failure to observe these conditions and
installation instructions can cause injury and
damage.
• The system is to be installed and maintained
only by trained and qualified personnel.
• Do not apply power until all ground
connections have been made.
• The unit is fitted with pressed and folded
metal parts, which could have sheared
metal edges. Be cautious handling the unit,
especially when working in poorly accessible
places.
• Check that no tools, test equipment, torches
etc. have been left in or on the equipment on
completion of work.
• Ensure the cover(s) and all mounting hardware
is firmly secured before leaving installation.
• All cable and connectors must conform to UL
standards.
• Most models are UL recognized and tested to
UL484. It will comply where necessary within
the safety requirements as defined in UL484.
• When servicing the unit, do not remove the
cover(s) for 5 minutes after switching the unit
off to allow pipe work (compressor discharge)
to cool.
WARNINGS
INTRODUCTION:
This installation manual and
the product uses various displays and labels
to ensure safe use. Ignoring these displays and
labels and incorrectly using the product could
have results as classified below. Please read the
following warning symbol information before
reading the rest of this section, and be sure to
strictly observe all instructions.
GENERAL PRECAUTION:
This appliance is
not intended for use by persons (including
children) with reduced physical, sensory or
mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of
the appliance by a person responsible for their
safety. Children should be supervised to ensure
that they do not play with the appliance. If the
power cord is damaged, it must be replaced by
the manufacturer, a service agent, or a similar
qualified person in order to avoid a hazard.
WARNING:
Not following these instructions
could result in death or serious injury.
CAUTION:
Not following these instructions
could result in injury or property damage.
This symbol will show for something that
should NOT be done.
Project safety is your responsibility! Follow
the instructions in this manual regarding the
installation method and installation orientation.
Not following these instructions could result
in injury, death, or damage to equipment.
All work should be performed by qualified
personnel using safe work practices. All proper
protective equipment should be used. PPE
required for this installation may include, but is
not limited to: Safety glasses | Hard hat | Safety
shoe | Hearing protection | Cut resistant gloves
| Face shield | Proper work attire (long sleeve
shirt and long pants)
