23
062
36
7 •
V
ersi
on
1.
0 •
14
.02
.2
011
Starting up and shutting down the air conditioner,
continued
Fault,
continued
•
Compressor thermo relay:
Running current for the compressor is too high
•
OT thermostat (only in models with heating installed):
High air temperature, or non-operating evaporator fan has stopped the heating coil
Refer to the “Fault finding guide”, page 33 for possible solutions.
Shutting down
Follow this procedure to shut down the air conditioner from any mode of operation:
Step
Action
1
Turn the function toggle switch to OFF
Result: All operations stop instantly
Warning: The evaporator fan will continue to operate, or start up, even with
the function switch in zero position, if the temperature inside the ACU ex-
ceeds 50 °C.
The fan stops, with the function switch in zero position, as soon as the tem-
perature drops below 35 °C
2
Release the two snap catches and unscrew the two hand screws, from their
parking position and pull the unit back into the container
3
Secure the door of the trap door system by means of the two snap locks on
the outside of the shelter and secure the ACU by the two hand screws at the
tip of the horns.
If the shelter is to be transported under slung by helicopter, mounting the
safety pin of the trap door system is mandatory.
4
Disconnect the power cable at the power supply and coil the cable if:
•
the air conditioner is put aside for a longer period or
•
if service is to be performed
