33
045787
•
Ve
rs
io
n
1.
2
•
27
.10
.2
0
1
5
Accessories
Introduction
Further information about individual accessories can be obtained from Dantherm A/S.
List
The complete list of accessories for AD 400 B with drawing, description and product
number is shown below:
Accessory
Illustration
Description
Product
number
Hygrostat
The dehumidifier is designed for
connection to an external hy-
grostat which is used when the
maintenance of a certain RF val-
ue is required. The hygrostat
can be set from 30-100% rela-
tive humidity.
The cable from the hygrostat
must be provided with a male
connector that fits into the de-
humidifier's hygrostat connector
on the front of the cabinet.
351036
Back plate
For standard operations minor
low pressure may occur in the
room where the dehumidifier is
located, because the regenera-
tion air is led from the room via
duct. This may in some cases
not be desirable and in such
cases the back plate with two
stubs for process air, in and re-
generation air, in may be used.
351039
Electrical wire
holder
Used if mounting of electrical
wires is required.
351035
Dew point con-
trol DH24
Combines an electronic hygro-
stat and dew point control in
one and the same product. DH
24 consists of a connection box
with humidity and temperature
sensor and a separate control
panel.
351037
xxx
