3. INSTALLATION
7
3.3 Installation of modules
Before placing the single modules in the right order, accordingly to chapter 3.2 the wooden
crossbeams or pallets have to be removed and the separate delivered feet mounted on the
base frame. To do so the following has to be done:
•
Unwrap the module, open the inspection door and take out the separate box with the
feet and the assembly rails for the unit.
•
On the fan module remove the transport brackets (1) which are holding the fan (spring
vibration dampers only) as it is easier now then after the unit has been assembled
(see drawing).
•
Check the ru
bber sealing’s (2) at the end of each module that they are not damaged
or loose. This is very important, as it is impossible to replace the sealing’s after the
modules have been assembled!
•
Lift the unit with a fork lift or pallet lift and unscrew the wooden cross beams.
•
Screw
the feet’s to the base frame and place the module as close as possible together
where they should be installed. When the feet are mounted it is only possible to move
the section for a few millimetres, otherwise the feet can bend or break. If you have to
move the sections more, then use a fork lift or pallet lift.
1
2
Summary of Contents for DanX AF 12/24
Page 1: ...DanX Pool AF User Manual Rev 2 3 961405 en...
Page 28: ......
Page 29: ......
Page 30: ......
