Pa
ge
4
GENERAL
INFORMATION
GENERAL REMARKS
This manual is an integral part of the machine, therefore it should always be carefully kept and it should always be
provided together with the machine, if it is transferred to another owner or user. If this manual is damaged or lost, a new
one should be requested from the local Technical Assistance Service or from the Manufacturer.
After unpacking the product, check the integrity and completeness of the contents. If not, contact the Agency that sold
the unit.
The installation of the appliance must be carried out by an authorized company which, at the end of the work, issues to
the owner the Declaration of Conformity of Installation made in accordance with the rules, therefore in accordance with
the Standards and the instructions provided by the Manufacturer in this instruction manual.
This appliance has been manufactured for room heating and it must be used for this purpose, compatibly with its
performance characteristics.
Any contractual or extra-contract liability of the Producer in respect of damages caused to people, animal or things by a
non correct installation, setting or maintenance or by the improper use of the machine is excluded.
If the temperature is too high, it could be harmful to health and would be a useless waste of energy. Do not leave the
rooms closed for a long time. Periodically open the windows to ensure proper ventilation.
During the initial start-up, there may be the formation of odours and fumes due to the evaporation of the liquid added to
protect the heat exchanger during storage; this is normal and it will disappear after a short period. It is recommended to
suitably ventilate the room.
If you will not be using the unit for long periods, carry out the following operations:
•
turn the main switch of the unit and the general switch of the plant to "OFF"
•
close the main fuel supply valve
In case of long periods during which the equipment is not operated, it is recommended to contact either After-Sales
Technical Assistance Service or anyhow professionally qualified personnel for its new start-up.
The machine shall be fitted only with original accessory equipment. The Producer is not liable for damages arising from
the improper use of the machine or from the use of non-original materials or accessories.
References to Laws, Regulations, Directives and Technical Rules mentioned in this manual are provided only for
information purposes and as they are in force when the manual is printed. The entry into force of new provisions or
amendments to current laws does not represent an obligation of the manufacturer towards third parties.
Repairs or maintenance must be performed by the Technical Assistance Service or by qualified personnel in accordance
with this manual. Do not modify or tamper with the appliance as dangerous situations can be created and the
manufacturer will not be liable for any damage caused.
The systems that are to be created (gas pipes, power supply, etc.) must be suitably secured and must not be dangerous
with the risk of tripping.
The Producer is responsible for the product compliance with Laws, Directives or Construction Rules in force when the
product is marketed. The knowledge and observance of the laws and standards regarding plant design, installation,
operation and maintenance are the sole responsibility of the designer, installer and user.
The Producer shall not be held responsible for failure to comply with the instructions of this manual, for the
consequences of any operations carried out and not specifically provided for or for translations open to misinterpretation.
The electrical system must feature suitable individual and independent electrical protections for each appliance which, in
case of accidental failure, will be activated on the single appliance without prejudice to the proper operation of the other
units present on the installation.
The appliance is designed to be operated with the heating capacity and the air flow rate specified in the Data
Sheet chapter. If the heating capacity is too low and/or the air flow rate is too high, combustion products may
condensate, resulting in the irreparable corrosion of the heat exchanger. If the heating capacity is too high
and/or the air flow rate is too low, an anomalous overheating of the heat exchanger may occur, resulting in the
activation of the safety devices and causing damage to the exchanger
