23
0
4
5
8
9
3
•
V
e
rsi
o
n
2
.3
•
1
6
.0
3
.2
0
1
2
3.1 How to unpack and mount the MTS4-outdoor enclosure,
con-
tinued
Procedure
Follow these steps to unwrap and mount the enclosure:
Step
Action
1
Remove the wrap and the straps
Check the enclosure for damages
The enclosure is delivered without having
the cover panels to plinth and protection
cover for surge arrestors installed. These
panels are supplied in a separate pack-
age with appropriate fasteners
2
Remove the 4 screws (13 mm head) that
are securing the enclosure to the pallet
and lift it off the pallet
3
Prepare the mounting site according to the mounting template in
Appendix
A
4
Secure the enclosure to the foundation in minimum 6 anchor points split on
at least 3 sides
5
Install the power according to the
section “3.2 How to install power to the
NB: To avoid condensation and thereby a potential risk of damage to
the installed equipment it is important that the enclosure is powered up
with as a minimum the installed 600W heater in operation within 24
hours after unpacking.
6
Place the front and rear panels (these are the longer ones and they are
alike) to their designated positions on the plinth. Note that one of the two
long cover panels has a removable service cover. This can be used to get
quick access to i.e. a generator plug or similar stored in the plinth.
7
Add the flange on the left side and tighten
the 3 M6 screws with washer closest to
the rear side of the enclosure using a
5mm Allen key.
Tighten the upper and lower 2 of M6
screw with washer closest to the front
side of the enclosure using a 5mm un-
brako key.
Continued overleaf