25
0
4
5
8
9
3
•
V
e
rsi
o
n
2
.3
•
1
6
.0
3
.2
0
1
2
3.1 How to unpack and mount the MTS4-outdoor enclosure,
con-
tinued
Procedure,
continued
Step
Action
12
The rooftop of the enclosure is removable
by untighten the 3 screws on left and right
side.
Should further protection towards theft of
rooftop be desired, 2 additional holes for
“security” rivets can be found on each
side (marked with a red circle)
13
Earth protection (towards antennas) con-
nection point can be found on each cor-
ner of the enclosure bottom plate, in ac-
cordance with the R56 requirements.
(Use M10 x 16 mm (max) screws and
washer to connect cabinet).
14
Power up within 24 hours to avoid condensation problems.
Activate heater as a minimum
15
The enclosure has a very robust and protective double coated paint.
This is essential part of corrosion protection insuring a long service lifetime
of the enclosure.
If the enclosure has got any damages on the paint with a risk of breaching
the corrosion protection it is important to repair these damages immediately
as part of the warranty obligations.
Appendix B is a check list to be used on the enclosure when commissioning
