6
1.1 General information
Introduction
This section gives the general information about this service manual and about the
MTS4-outdoor enclosure.
Manual,
part number
Part number of this service manual is 045893.
For Fuel Cell power backup option: please see the manual
IPSM-A1600 power backup
module for installation in the MTS4-outdoor enclosure
(product no. 046234).
Target group
The target group for this service manual is the technicians who install, maintain, and
exchange parts on the unit.
Copyright
Copying of this service manual, or part of it, is forbidden without prior written permis-
sion from Dantherm Air Handling A/S.
Reservations
Dantherm Air Handling A/S reserves the right to make changes and improvements to
the product and the service manual at any time without prior notice or obligation.
MTS4-outdoor en-
closure
Dantherm Air Handling A/S, Marienlystvej 65, DK-7800 Skive hereby declare that the
product mentioned below:
Product No.:
352894 MTS4 outdoor enclosure basis
and the 2 versions below with enclosure extensions for storage
352895 MTS4 outdoor FC-5
352896 MTS4 outdoor FC-3
are in conformity with the following directives covering the provisions of the normative
European Council Directives:
2006/42/EC
Directive on the safety of machines
2006/95/EC
Low Voltage Directive
2004/108/EC
EMC Directive
Description: MTS4 outdoor enclosure is a 2 door steel based outdoor enclosure
equipped for accommodating and servicing an MTS4 radio base station. The enclosure
has multiple configurations ranging from a standard configuration with only a basic set-
up up to a full integrated option list as defined in the service manual no 045893. Basis
is equipped with a door mounted heat exchanger (CE marked), a power distribution
panel (CE-marked) and internal cables, cabin lights, a backup installation (battery pack
using VRLA size batteries (optional)), battery charger, surge arrestors etc. Items not
listed in the service manual are not covered by this declaration.
The versions 352895 and 352896 with enclosure extensions for storage also offers a
power backup system (IPSM-A1600) based on fuel cell technology using hydrogen as
energy source. This backup system is CE-marked and further described in manual p/n
046614.
and Manufactured in conformity with the following harmonised standard:
EN60529:2001
IP55 (Degree of protection provided by enclosures)
EN 12000-1:2005 Safety of machinery
– Part 1: Basic terminology
EN 12000-2:2005 Safety of machinery
– Part 2: Technical principles
EN 60 950-1:2006 Installation safety (CB by Intertek, ref: 714719-01)
EN 60 950-22:2006Information technology equipment - Safety - Part 22:
Equipment installed outdoors
EN50272-2:2001 Battery installation
Continued overleaf
