6
www.danvex.fi
2
DEVICE INFORMATION
2.1
Standards
The design of the dehumidifier complies with protection class IP 44, IEC standard
.
2.2
How it works
The main component of the installation is a honeycomb rotor, consisting of a special ceramic
fiber and active silica gel. The two sides of the rotor are separated by special hermetic seals into
two zones: the working zone, which is 3/4 of the rotor surface, and the regeneration zone, 1/4
of the rotor surface. When moist working air passes through the filter into the rotor, the moisture
from the air is absorbed by the dehumidifying working sector of the rotor, and the dehumidified
air is expelled from the other side of the rotor by the fan. At the same time, the regeneration air
passes through the filter, heats up and enters the regeneration sector of the rotor. In this zone,
the heated regeneration air removes from the rotor the moisture previously adsorbed
by the silica gel, which is then removed in the form of steam from the dryer and into the street
.
Schematic diagram of the operation of an adsorption dryer
Note
:
the diagram does not show the obligatory filters for working and regeneration air
