DAPAudio COM-2.4, Manual

5 

COM-2.4 

Order code: D1410  

Set Up and Operation 

Receiver installation 

Location 

For best operation the receiver should be at least 1 meter above the ground and at least 1 meter away 
from a wall or metal surface to minimize reflections. Keep the receiver antenna away from noise sources 
such as other digital equipment, microwave ovens, as well as large metal objects. Keep COM-2.4 
receiver 9 meters away from wireless access points . 

 
Output Connection 

There is one audio output on the rear panel: unbalanced 1/4" TRS phone jack. Use a shielded audio 
cable to connect the receiver and the mixer. 
 

Power Connection 

Connect the supplied power adapter to the DC power input on the back of the receiver.  
Make sure the plug can’t be disconnected by an accidental tug on the cord. 
 
The receiver has no power Off / On switch. The receiver will be energized whenever the power adapter is 
connected and plugged into the AC outlet. Unplug the power supply from the AC outlet when the  
system is not in use, both for safety and conserving energy. 

 
Antenna 

Rotate the permanently attached antenna vertically to get the best reception .