10
Example 2:
using the 4
Ω
output with four 4
Ω
speakers
Fig. 6
Example 3:
using the 8
Ω
output with two 4
Ω
speakers.
Fig. 7
In a low impedance system, the total speakerload should always match the amplifier
impedance This to avoid overloading the amplifier. The total speaker power should be at least
the power of the amplifier to avoid damage to the speakers.
High impedance outputs
If using either the 70V outputs or the 100V outputs, note that all speakers should be wired in parallel.
The total power of all speakers summed together should never exceed the total power of the
amplifier in a high impedance (70V or 100V) system!
Summary of Contents for D6146
Page 15: ...2013 DapAudio ...
