15
Ordercode: D2289
GIG-202 Tab
LINK select button
Input channels, Aux buses and subgroups can be linked as a stereo pair. The button will light up to
indicate that the stereo link is active. The stereo pairs are predefined and cannot be changed. They
are as follows:
Channels 1 and 2
Channels 9 and 10
Aux 1 and Aux 2
Channels 3 and 4
Channels 11 and 12
Aux 3 and Aux 4
Channels 5 and 6
Channels 13 and 14
Subgroups 1 and 2
Channels 7 and 8
Channels 15 and 16
Subgroups 3 and 4
A stereo link can be enabled when either channel in the pair is selected, by pressing the link button.
When the Link button is illuminated, indicating that the Stereo Link function is enabled, all DSP
settings, subgroups assignments, solo status and main assignments are passed to the other channel
of the pair.
Link & DCA
Apart from link, the channels can also be grouped to DCA as stereo channel, but without the
possibility to channel the link in DCA. On the contrary, if the channel has been grouped to DCA, it
cannot be linked at all, while its paired channel can link.
For example: channel 5 is linked to channel 6, then both channels can be grouped to DCA.
However, if channel 5 has been grouped to a DCA first, it cannot be linked to channel 6, but
channel 6 can be linked to channel 5.
Link and Routing
The two linked channels can route as stereo channel, while routed channels can also link later.
Please note that this is a non-destructive passing. The other channel’s previous setting will be
restored after the link button gets disengaged. For example, when channel 6 has been selected,
then press the Link button. All of the channel 6 settings will be copied to channel 5. The channel 5’s
own settings will be restored after the Link button has been pressed again.
Summary of Contents for GIG-202 Tab
Page 62: ...61 Ordercode D2289 GIG 202 Tab Block Diagram...
Page 64: ...2016 DAP Audio...
