DAPAudio IPS-EA, Manual

2 

WARNING 

FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY  

BEFORE YOUR INITIAL START-UP! 

SAFETY INSTRUCTIONS 

Every person involved with the installation, operation and maintenance of this system have to: 

-

be qualified 

-

follow the instructions of this manual 

Before you initial start-up, please make sure that there is no damage caused by transportation. Should there 
be any, consult your dealer and do not use the system. 
 
To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to follow 
the safety instructions and warning notes written in this manual. 
 
Please consider that damages caused by manual modifications to the system are not subject to warranty. 
 
This system contains no user-serviceable parts. Refer servicing to qualified technicians only. 
 

IMPORTANT:

The manufacturer will not accept liability for any resulting damages caused by the non-observance 
of this manual or any unauthorized modification to the system. 

Never let the power-cord come into contact with other cables! Handle the power-cord and all 
connections with the mains with particular caution! 

Never remove warning or informative labels from the unit. 

Never use anything to cover the ground contact. 

Do not insert objects into air vents. 

Do not connect this system to a dimmer pack. 

Do not switch the system on and off in short intervals, as this would reduce the system’s life. 

Do not open the device and do not modify the device. 

Do not open this device. Risk: hazardous radiation exposure. 

Only use system indoor, avoid contact with water or other liquids. 

Avoid flames and do not put close to flammable liquids or gases. 

Always disconnect power from the mains, when system is not used. Only handle the power-cord by 
the plug. Never pull out the plug by tugging the power-cord. 

Make sure you don’t use the wrong kind of cables or defective cables. 

Make sure that the signals into the mixer are balanced, otherwise hum could be created. 

Make sure you use DI boxes to balance unbalanced signals; all incoming signals should be clear. 

Make sure that the available voltage is not higher than stated on the rear panel. 

CAUTION! 

Keep this system away from rain and moisture! 

CAUTION! Be careful with your operations. 

With a dangerous voltage you can suffer 

a dangerous electric shock when touching the wires!