6
Back panel
Fig. 2
13.
IEC Power Inlet and Fuse.
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, then turn on the power switch (1) to operate
the unit.
Note:
Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains.
Replace the fuse only with a fuse of same specification (T315mA).
14.
GND Screw.
This screw offers a separate ground connection. Can be useful in case of grounding problems.
15.
DC 24V Input.
Used to connect an external back up power supply of 24Vdc (e.g. Battery).
16.
GND Lift Switch.
To eliminate grounding problems.
17.
Remote Out A/B.
Relay outputs (N.O. contacts) are closed if an alarm signal is present.
18.
Remote In A/B.
Need to be connected to a “normally open” contact type. Closed contact means alarm.
19. Line In.
Aux input, used for recording.
20.
Alarm Out.
Used for sending the alarm signal/ message to an external amplifier.
Summary of Contents for IPS-EA
Page 1: ...IPS EA ORDERCODE D6504 ...
Page 12: ...2007 DapAudio ...