5
Backside
5. Power cord
6. Fuse
7. 5-way Binding post output Connectors
8. Signal Ground Lift Barrier Strip
9. Bridged, Parallel, Stereo
10. Balanced Phone Jack Inputs
Installation
Palladium Vintage Installation
Remove all packing materials. Check that all foam and plastic padding has been removed.
Screw the equipment into a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Do not supply power before
all components of the system are
set up and connected properly.
Connection Input
The balanced phone jack inputs have a nominal impedance of 20 KΩ (10KΩ with unbalanced wiring) and
will accept the line level output of most devices. The correct input depends on 2 factors: (1) whether the
input signals are balanced or unbalanced, and (2) whether the signal source floats or has ground reference.
Figures provide examples of recommended connection techniques for each type of signal source. The
optional connector is shown.
The amplifier’s built-in 1/4“-Input-Phone-Connectors can be wired similarly for balanced or unbalanced,
floating or ground-referenced sources.
Summary of Contents for Palladium P-400
Page 14: ...2003 DapAudio...
