7
Ordercode: D3506
PR-62 65W
Maintenance
The DAP Audio PR-62 requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the audio connections with a damp
cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
If the speakers do not operate properly, refer servicing to a technician.
Suspect two potential problem areas as: the power supply and the speakers.
01)
Power supply. Check if the unit is plugged into an appropriate power supply.
02)
The speakers. Return the PR-62 to your DAP Audio dealer.
03)
If both appear to be O.K., plug the unit in again.
04)
If you are unable to determine the cause of the problem, do not open the PR-62, as this may
damage the unit and the warranty will become void.
05)
Return the device to your DAP Audio dealer.
Sound Warping
If the sound coming out of your speaker is loud enough, but seems to be warped or distorted, your treble
or bass levels may need to be adjusted.
If there are not many pieces of furniture in the room and the floor has no carpet or rug, then you will most
likely have to set your treble to minus. With very little in the room to absorb the sound, too much treble
can make the sound bounce off of fixtures in the room, making it tinny sounding.
With the bass, if the speaker is too close to a wall and is not aimed properly, then you will need to set the
bass to minus, to stop the low tones from bouncing off of the walls or large pieces of furniture.
Product Specification
Power consumption:
65W RMS
Impedance:
16 Ω
Woofer:
6,5”
Tweeter:
12,6 mm Mylar Dome Tweeter
Frequency range (-10 dB):
50 Hz – 20 kHz
Connections:
speaker cable connector IN
Color:
White
IP rating:
IP20
Dimensions:
190 x 215 x 290 mm (LxWxH)
Weight:
6,3 kg
Design and product specifications are subject to change without prior notice.
Summary of Contents for PR-62 65W
Page 9: ...8 Ordercode D3506 PR 62 65W Dimensions...
Page 10: ...9 Ordercode D3506 PR 62 65W Notes...
Page 11: ...10 Ordercode D3506 PR 62 65W...
Page 12: ...2018 DAP Audio...
