5
Installation
Palladium 100V Installation
Remove all packing materials. Check that all foam and plastic padding has been removed.
Screw the equipment into a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Do not supply power before
all components of the system are
set up and connected properly.
DC power or battery supply's connection
•
The unit will also operate with 2 external 24V batteries or another source with positive and negative (-)
voltage against ground. Power connection is made at the DC terminal strip on the real panel.
•
If the AC power supply fails, transfer to DC power is instantaneous, automatic and silent.
•
The amplifier is not capable of recharging the connected battery.Thus, it is recommended to have a
suitable device at hand. When the amplifier is on the DC power source, the nominal power handling
capacity operated drops and will not reach full power capacity.
Fig. 3
