cPCI-FRM11 User’s Manual (Rev 1.1)
-
23
- http://www.daqsystem.com
(3) „
Clear Serial Data’ button
Press this button to clear the contents of the editor box.
(4) „
Start Timer’ button
Press this button to start the timer. The sample program will read the UART data periodically.
The reading interval is around 0.1s.
(5) „
Stop Timer’ button
Press this button to stop the timer.
(6) „
UART Init’ button
Press this button to initialize UART. It must be performed only once after power is applied to
the board.
(7) „
UART Close’ button
Press this button to finish usage of the board and terminate the program.
5.1.3 Functions related to DIO
(1) „
DIO Read’ button
Press this button to read the data on General Purpose I/O port. It will be written an editor box.
(2) „
DIO Write’ button
Press this button to write the data on General Purpose I/O port. You can directly write the data
in the editor box beside the button.
