USB-DIO6400 Users Manual (Rev 1.1)
-
22-
http://www.daqsystem.com
(3)
„Open Device‟ button
Open the selected Board. This button has to click after changed the board number.
(4)
„Exit‟ button
Stop the program
(5)
„DIN Read‟ button
When the button click, a value to read an input port is marked to hex number at a window
beside
“DIN 31..0”.
Example) If it reads a
”00008001”, the number 15 and 0 get to “On” state.
* The
“DIN 63..32” is a reservation window for future.
(6) Auto DIN Read
When check
“Auto DIN Read”, you confirm it right now.
(7)
„DOUT Read‟ button
When click the button, a value to read an output port is marked to hex number at a window
beside
“DOUT 31..0”.
* The
“DOUT 63..32” is a reservation window for future.
(8)
„DOUT Write‟ button
When click this button after a value will be written an output port at a window beside
“DOUT
31..0
”, a value of each bit will be display.
Example) If it reads a
”00008001”, the number 15 and 0 get to “On” state.
* The
“DOUT 63..32” is a reservation window for future.
(9) Auto DOUT Test
When check
“Auto DOUT Test”, from bit 0 to bit 31 get to “On” in turn.
(10)
„List Device‟ button
It displays a board number which installed in a system.
