SETTING UP THE AWNING - ATTACH TO TENT
•
Once the tent is inflated and secured, it is time to
attach the awning if it is required.
•
Locate the zipper head on the awning
A
and engage
it with the zip slide on the left hand side of the tent
B
.
Complete the zip.
•
The additional zips on either side of the awning are to
attach awning walls. (Sold separately).
ATTACH THE AWNING TO THE POLES
•
Locate the 3 eyelets on the awning
A
and insert a pole
spigot into each eyelet
B
.
•
Centre and adjust the pole to the desired height. Tie a
loop on the ends of the supplied guy ropes and place
over the spigot
C
.
•
Tension the guy ropes with the supplied hook
tensioners
D
. Refer recommended guy rope
positions on previous page.
•
Note: The tent has 3 x twist lock poles
E
included. 1
longer pole for the centre eyelet and 2 shorter poles for
the outside eyelets.
Note: During wet conditions, it is essential the
awning poles are lowered to allow sufficient slope
for water run-off.
WARNING: IN ADVERSE CONDITIONS, IT IS
STRONGLY ADVISED TO REMOVE THE AWNING
FROM THE TENT TO AVOID DAMAGE AND
INJURY.
5
6
B
A
B
AWNING
TENT
A
B
C
D
E
AT-4 AND AT-6 TENT SET-UP & CARE INSTRUCTIONS