49
Removing a Test Strip from the Cartridge
You should have a test strip cartridge already inserted in your
Dario Housing. If this is not the case, refer to
Inserting the Test
Strip Cartridge
on page
21
.
To remove a test strip from the cartridge:
1.
Wash your hands with warm, soapy water and dry thoroughly. If you use
alcohol wipes to clean your fingers, ensure the puncture area is
completely dry before lancing your finger.
2.
Remove the cartridge cover of the Dario Housing by pushing it outwards
until it comes off (use the removal indication lines), as shown in the
image below.
3.
Open the lid by pushing up the edge, as shown in the image below.
!
