Controlling the touch sliders is easy - swipe upwards
to boost a frequency band or swipe downwards to
cut a frequency band.
When swiping, the position of the slider is also
reflected on the potentiometer LEDs. Double-tap
the slider to reset the band back to 0 dB.
Hint: The sliders respond to the direction of your
swipe on any part of the slider, so you can make
small adjustments without your finger covering the
actual position of the slider.
ROTARY FOOTSWITCH ENCODERS
Below the touch sliders are three rotary footswitch
encoders
A, B, and C, which can be pressed or
rotated. These footswitch encoders enable many of
ADAM’s functions. Simply press
A, B, or C to switch to
the preset stored in that footswitch.
The rotational position of each encoder is displayed
on the five LEDs under each encoder. Additionally,
when rotating, the position is shown on the
potentiometer LEDs - this is a visual aid that does not
affect the potentiometer configuration.
· Rotating
A allows you to change the compressor
ratio or bypass the compressor.
· Rotating
B allows you to change the distortion
mode or bypass the distortion.
· Rotating
C allows you to change the active IR in
the signal chain or bypass the IR.
When none of the five LEDs are lit, the respective
compressor/distortion/IR is bypassed.
