When tuning, the two rightmost sliders will update
to show how close your tuning is from the note’s
perfect pitch. Distance below the center line
indicates that the note is tuned flat, and distance
above the center line indicates that the note is tuned
sharp. The red LEDs will transition to green as you
approach the perfect pitch, and the slider and preset
LEDs will fully illuminate in green when you are on
perfect pitch.
BYPASS
To enter the bypass mode, press
A and B
simultaneously.
To exit the bypass mode, press
A and B simultaneously
or one of the footswitch presets.
In this mode, ADAM does not perform any processing
on the input signal, and passes the unprocessed
input signal through to the outputs. All LEDs are
turned off during bypass mode.
PERFORMANCE LOCK
To enter or exit the performance lock, press
A and C
simultaneously.
In this mode, all LEDs will gently breathe on ADAM to
indicate that it has been locked.
This mode prevents any accidental parameter
changes or edits to your presets. You can still change
between the saved presets
A, B, and C, and enter the
tuner or bypass modes, but potentiometer updates,
slider touches, or encoder rotations will not respond
to any changes.
Tip: Enter the performance mode after the
soundcheck while playing live gigs.
BLUETOOTH PAIRING
To begin Bluetooth pairing with ADAM, press and
hold an encoder while simultaneously rotating the
encoder. The five LEDs under each encoder will
illuminate one-by-one, and pairing will begin when
all five are lit. Look for “ADAM” on your list of available
bluetooth devices.
