Vintage Microtubes
Vintage Overdrive
No tube, no problem
The Vintage Microtubes is our tribute to some of the most legendary
sounds in rock history. It provides warm tube-like tones with a natural
dynamic response that echoes the organic compression of old tube
amps and reel-to-reel tape machines.
Warning
The Vintage Microtubes has a current draw of 20mA. Only use a
regulated 9V DC adapter with a center-negative plug. Due to
ecological reasons it does not accept batteries. Unregulated power
supplies and/or higher voltages may result in suboptimal noise
performance and even damage your unit, voiding the warranty.
Warranty
To activate the warranty, we encourage you to register your product
on: http://mypedal.darkglass.com and enter the serial number on
the back of your pedal.
Please contact us via email support@darkglass.com before
shipping a product to us.
Controls
BLEND
: Mixes the clean input signal with the overdriven signal. The
clean signal remains at unity gain while the volume of the
overdriven signal is set by the Level knob, allowing for fine control
of the blend ratio.
LEVEL
: Sets the volume of the overdriven signal.
DRIVE
: Sets the amount of saturation in the overdriven signal.
ERA
: Interacts with the Drive knob to shape the character of the
pedal. Dial it down to get the warm midrange tones of the 70s or
crank it up to get the punchy metallic tones of 80s and 90s rock.
Disclaimer
In the interest of continuous improvement, specifications are subject
to change without notice. If you have any questions, please don’t
hesitate to contact us at www.darkglass.com
The manufacturer claims that the above product fulfills the
requirements as set by EN55013, EN55020, EN60555-2, EN60555-3,
RoHS, WEEE.
