5
DART-SVP Source Rev 2:
(SN: SVPS002XX)
The revision 2 DART-SVP source, pictured below, has an X-Rail Cradle but it is not removable from the
source baseplate. Simply place the linear rail directly into the cradle on the baseplate, and lock into place
using the two set screws.
As with the Rev 1 source, reference the
Hardware and Network Installation Manual v2
to determine the
exact placement of the rail in the cradle.
Y-RAIL Installation:
Repeat the process to attach the Y-Rail to its cradle. Slide the non-motor end of the rail into the
housing, leaving it so the end of the rail is flush with the end of the cradle. Again, using the
1.5mm Allen wrench, tighten the set screws to lock the rail in place.
Figure 4, a,b, and c: the Y-Rail with its cradle; the Y-Rail in its cradle; locking the Y-Rail in place.
