Correct tightening of the bicycle fasteners, nuts, and bolts are essential. Too little force and the fastener may
not hold securely. Too much force and the fastener may tear, stretch, distort or break the thread. Either way,
incorrect torque can damage the component, which can cause you to lose control and fall. In case of doubt or
problems found during your test ride, seek immediate advice from a professional bicycle mechanic.
See the instructions of the suppliers of the suspension fork, rear shock, and other parts that come with this
frame. Do not use the bicycle until all problems have been resolved. Riding a bicycle with any defects may be
dangerous to health and life. If you are not a qualified bicycle mechanic, do not make any of these adjustments
yourself and seek advice from your local bicycle dealer.
The rear suspension bolts (rear shock and pivots) have been tightened at the factory to the specified torque.
If you re-adjust, take particular care when re-tightening.
DO NOT
lubricate any of the pivot points. The factory
uses high-quality self-lubricating Teflon.
Tightening torques (Nm) for individual points on the frame:
• Main pivot assembly: 20 Nm
• Rocker-seat stay pivot assembly: 10-12 Nm
• Chainstay-seat stay pivot assembly: 10-12 Nm
• Rocker main pivot assembly: 20 Nm
CS Protector for Thunderbird CF/AL
Thermoplastic elastomer chainstay protector for Thun-
derbird CF, Thunderbird Superenduro, and Thunderbird
FR frames.
Weight:
48g
DT Protector for Thunderbird CF
Thermoplastic elastomer down tube protector for Thun-
derbird CF frame.
Weight:
92g
8. TIGHTENING TORQUE
ACCESSORIES
:
The rocker arm neoprene tube protector should be
wrapped together with the rear derailleur cable to
protect the rocker arm from chain impacts.
A self-adhesive set of protective films can be used
for additional protection of the downtube.
Before applying the protective film to the frame,
degrease and clean its surface.
6
Nm
10-12
Nm
6-8 Nm
(Shimano)
10-12 Nm
(Sram)
*
*UWAGA:
moment obrotowy różni się w zależności od producenta;
sprawdź w instrukcji obsługi hamulów rowerowych.
• Upper shock bolts: 10-12 Nm
• Lower shock bolts: 10-12 Nm
• UDH compatible derailleur hanger/frame axle: 25 Nm
18
*NOTE:
depends on the brake manufacturer,
please check your brake manual
