- 2 -
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions ;
(1) this device may not cause harmful Interference, and (2) this device must
accept any interference received, Including interference that may cause
undesired operation.
Dasan Electron Co.,Ltd.
Product: Bluetooth Headset
Model No : DA-581BT
FCC ID : WF2DA-581BT
Bluetooth Headset
Owner’s Manual
DA-581BT
- 3 -
•
CAUTION
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user’s authority to operate the equipment.
•
INFORMATION
This device and its antenna(s) must not be co-located or operating in conjunction with
any other antenna or transmitter except in accordance with FCC multi-transmitter
product procedures.
The use of a permanently attached antenna or of an antenna that user a unique
coupling to the intentional radiator shall be considered sufficient to comply with the
provisions of required this section.
The manufacturer may design the unit so that broken antenna can be replaced by the
user, but the use of a standard antenna jack or electrical connector is prohibited.
※
STATEMENT
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, users, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocated the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
