UMN:CLI
User Manual
V5824G
318
8.7
Rate Limit
User can customize port bandwidth according to user
’s environment. By this configuration,
you can prevent a certain port to monopolize whole bandwidth so that all ports can use
bandwidth equally. Egress and ingress can be configured both to be same and to be
different.
The V5824G can apply the rate limit with 64 Kbps unit for GE port, and support ingress
policing and egress shaping.
To set a rate limit for ports, use the following command.
Command
Mode
Description
rate-limit port
PORTS
rate
RATE
{
egress
|
ingress dot3x
}
Bridge
Sets a rate limit for ports. If you input egress or ingress,
you can configure outgoing packet or incoming packet.
The unit is 64 Kbps.
no rate-limit port
PORTS
{
egress
|
ingress dot3x
}
Clears a specified rate limit for port.
For the ingress rate limit, the flow control should be enabled on a specified port! For more
information of the flow control, see Section
To display a configured rate limit, use the following command.
Command
Mode
Description
show rate-limit
Enable
Global
Bridge
Shows a configured rate limit.
!
