User Manual
UMN:CLI
V5824G
49
4 System Connection and IP Address
4.1
System Connection
After installing the system, the V5824G is supposed to examine that each port is correctly
connected to network and management PC. You can connect to the system to configure
and manage the V5824G. This section provides instructions how to change password for
system connection and how to connect to the system through telnet as the following order.
•
•
Password for Privileged EXEC Enable Mode
•
•
•
•
•
•
4.1.1
System Login
After installing the V5824G, finally make sure that each port is correctly connected to PC
for network and management. Then, turn on the power and boot the system as follows.
Step 1
When you turn on the switch, booting will be automatically started and login prompt will
be displayed.
SWITCH login:
Step 2
When you enter a login ID at the login prompt, the password prompt will be displayed,
and then enter the proper password to log in the system. By default setting, the login ID is
configured as
admin
with no password.
SWITCH login:
admin
Password:
SWITCH>
Step 3
In
Privileged EXEC View
mode, you can check only the configuration for the switch. To
configure and manage the switch, you should begin
Privileged EXEC Enable
mode. The
following is an example of beginning
Privileged EXEC Enable
mode.
SWITCH>
enable
SWITCH#