User Manual
UMN:CLI
V5824G
511
To specify the execution condition of ONU auto upgrade configuration above, you should
specify a target version of ONU firmware with (or without)
exclude
option. Through the
target version and the option, auto upgrade execution condition is determined.
To set the target version for ONU, use the following command.
Command
Mode
Description
onu auto-upgrade target-version
NAME VERSION
[
exclude
]
GPON
Sets the target version for ONU.
NAME: ONU model name
VERSION: target version
no onu auto-upgrade target-
version
NAME
Deletes the configured target version for ONU.
If
exclude
option is used, the auto-upgrade is performed only when the ONU
’s existing
firmware version is
different from
the specified target version. Otherwise, if
exclude
option is not used, the auto-upgrade is performed only when the ONU
’s existing firmware
version is
same as
the specified target version.
To display the target version configuration for ONU auto upgrade, use the following
command.
Command
Mode
Description
show onu auto-upgrade target-
version
GPON
Shows the target version configuration for ONU auto
upgrade.
(3) Specifying Time and Retry Count
•
Specifying Time for Auto Upgrade
You should set the clock of switch to start auto upgrade of ONU (download to ONU) at
specified time. To specify the time to start auto upgrade of ONU, use the following
command.
Command
Mode
Description
onu auto-upgrade model-name
NAME
start-
time
<
0-23>
end-time
<0-23>
GPON
Specifies the time to start auto upgrade of
ONU.
NAME: ONU model name
0-23: start/end time (unit: o
’clock)
onu auto-upgrade model-name
NAME
start-
time
disable
Deletes the specified time.
no onu auto-upgrade model-name
NAME
start-time
To see the ONU model name, use
show onu model-name
i
i
